pibot_cnc_laser_series:v496_pro:check_jumpers:start
目录
List 1：Check jumpers and power on
Please disconnect all external peripherals before starting.
Check Point 1
Only 3 jumpers by default from the factory ship
- VDD selected 3.3V,
- SW-VCC selected 5V,
- GPIO26 selected as relay output.
Check Point 2
- Insert antenna
- Insert OLED (optional)
- Insert TF Card (optional).
Check Point 2
- Connect 12V or 24V power (do not reverse polarity, default 24V).
- Switch on power
The result would shows
- 5V power indicator LED should illuminate
- OLED screen should display information/data (if OLED is installed)
pibot_cnc_laser_series/v496_pro/check_jumpers/start.txt · 最后更改: 由 admin