pibot_cnc_laser_series:v496_pro:test_0_10v:start
Table of Contents
List: 7 Test 0-10V Output
1
Measurement Setup
- Connect multimeter red probe to GPIO.13 (green terminal)
- Connect multimeter black probe to GND
2
0-10V Output Mode Activation
- Enter command:
M6 T3↵ - Switch to 0-10V output mode
3
0-10V Output Calibration & Testing
- Enter command:
M3 S24000↵ - Check if multimeter reads 10V
- ⚠️ If not 10V, carefully adjust potentiometer with screwdriver to achieve 10V
- Enter command:
M3 S12500↵ - Output voltage should change from 10V to 5V
- Enter command:
M5↵ - Output should return to 0V
Expected Results
- M3 S24000: Output reaches 10V (adjust potentiometer if needed)
- M3 S12500: Output changes from 10V to 5V
- M5: Output returns to 0V
- 0-10V output scales linearly with S-value commands
- Potentiometer adjustment allows precise 10V calibration
Image shows
Coming soon!
Video demonstrations
Coming soon!
Related YAML code
# Begin 10V 10V: forward_pin: NO_PIN reverse_pin: NO_PIN pwm_hz: 5000 output_pin: gpio.13 enable_pin: NO_PIN # direction_pin: NO_PIN disable_with_s0: false s0_with_disable: true # spinup_ms: 0 # spindown_ms: 0 tool_num: 3 speed_map: 0=0.000% 1000=0.000% 24000=100.000% off_on_alarm: false
This version of the WIKI is still being edited. You can check out previous videos.
Beginner upload firmware set webUI tutorial
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
// Relay // PWM // Laser // 0~10V // Output Test //
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
// Connect hardware // Limits // Probe // Motor // Relays
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
pibot_cnc_laser_series/v496_pro/test_0_10v/start.txt · Last modified: by admin