pibot_cnc_laser_series:v496_pro:test_relay:start
Table of Contents
List 4: Test Onboard Relay Output
1
Tool Change Command
- Enter command in WEBUI:
M6 T0
2
Activate Relay
- Enter command:
M3 S255 - You should hear relay "click" sound
- Corresponding LED should illuminate
3
Deactivate Relay
- Enter command:
M5 - You should hear relay "click" sound
- LED should turn off
Expected Results
- M3 S255: Relay activates with audible click and LED illuminates
- M5: Relay deactivates with audible click and LED turns off
- Relay responds correctly to all G-code commands
Image shows
Coming soon!
Video demonstrations
Coming soon!
Related YAML code
# Begin relay relay: direction_pin: NO_PIN output_pin: gpio.26 enable_pin: NO_PIN disable_with_s0: false s0_with_disable: true spinup_ms: 0 spindown_ms: 0 tool_num: 0 speed_map: 0=0.000% 0=100.000% 1=100.000% off_on_alarm: false
This version of the WIKI is still being edited. You can check out previous videos.
Beginner upload firmware set webUI tutorial
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
// Relay // PWM // Laser // 0~10V // Output Test //
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
// Connect hardware // Limits // Probe // Motor // Relays
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
pibot_cnc_laser_series/v496_pro/test_relay/start.txt · Last modified: by admin