pibot_cnc_laser_series:v496_pro:test_laser:start
Table of Contents
List 6: Test Laser PWM Output
1
Measurement Setup
- Connect multimeter red probe to GPIO.12 (green terminal)
- Connect multimeter black probe to GND
- (Alternative: Use oscilloscope for measurement)
2
Laser PWM Mode Activation
- Enter command:
M6 T2↵ - Switch to Laser PWM mode
3
Laser PWM Output Testing
- Enter command:
M3 S127↵ - Then enter:
G1 F1000↵ - Output should change from 0V to 2.5V
- Enter command:
M3 S255↵ - Then enter:
G1 F1000↵ - Output should change from 0V to 5V
- Enter command:
M5↵ - Output should return to 0V
4
Vmot Laser PWM Output (Optional)
💡
MOSFET ON/OFF measurement
- Connect red probe to MOSFET Vmot-main (orange terminal)
- Connect black probe to IO.12-MOS-GND (orange terminal)
- Enter command:
M3 S255↵ - Then enter:
G1 F1000↵ - Output: 0V to Vmot-main
- Enter command:
M5↵ turn off - used to drive Vmot-main voltage loads such as solenoid valves
Expected Results
- M3 S127 + G1 F1000: Output changes from 0V to 2.5V
- M3 S255 + G1 F1000: Output changes from 0V to 5V
- M5: Output returns to 0V
- Mosfet output ON/OFF correctly with refer commands
Image shows
Coming soon!
Video demonstrations
Coming soon!
Related YAML code
# Begin Laser Laser: pwm_hz: 5000 output_pin: gpio.12 enable_pin: NO_PIN disable_with_s0: false s0_with_disable: true tool_num: 2 speed_map: 0=0.000% 255=100.000% off_on_alarm: true
This version of the WIKI is still being edited. You can check out previous videos.
Beginner upload firmware set webUI tutorial
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
// Relay // PWM // Laser // 0~10V // Output Test //
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
// Connect hardware // Limits // Probe // Motor // Relays
The V4.9 plus and V4.8A V4.9A is similar config, different is the v4.9 plus step/dir model onboard driver “MS3 pin” need set in yaml.
pibot_cnc_laser_series/v496_pro/test_laser/start.txt · Last modified: by admin